Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
More information facilitates better communication.
Submitted successfully!
We will call you back soon!
Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
—— Moyo
—— Octavio
—— Cristian
—— Spence
—— Samuel
—— Ali
1. Oil pump switch is used to control the start and stop of the oil pump. Please open the oil pump before operation. To provide pressure for the hydraulic system, after the operation of the oil pump, pay attention to the operation direction of the oil pump should be consistent with the arrow direction. If not, please change any two of the three-phase power in the oil pump motor.
2. The lower cut and return buttons control the operation of the cutter. If the lower cut and return buttons are pressed, they are invalid. In general, it should be considered whether the hydraulic oil level of the hydraulic oil tank is too low, it should be added to the tank hydraulic oil, and in the process of cutting and returning the knife. When the limit switch in front is encountered, the operation will automatically stop.
3, the forward and backward is through the inverter control host forward and reverse operation. The speed can be controlled by the high/low speed switch on the panel. The speed switch must be placed at high speed during automatic operation.