Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
More information facilitates better communication.
Submitted successfully!
We will call you back soon!
Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
—— Moyo
—— Octavio
—— Cristian
—— Spence
—— Samuel
—— Ali
1, the press tile machine before, after the four corners of the two rows from the big frame to the height of the upper end of the shaft is consistent, and then from the first row to the last row, find a line straight, check, whether in a straight line, the left side of the shaft, the right side of the horizontal state.
2, find a good pressure tile machine first row and the last row of the center, and then firm both sides of the mother, in the middle of the center of the wheel before, after a good line, the gap between the shaft, can be adjusted along the straight line machine.
3, if the pressure tile machine in pressing steel plate to the right side of the run, need to find a hard pad under the left corner, if the left run, just the opposite need to pad under the right corner.