Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
More information facilitates better communication.
Submitted successfully!
We will call you back soon!
Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
—— Moyo
—— Octavio
—— Cristian
—— Spence
—— Samuel
—— Ali
1. The thickness of the profile is mainly based on the thickness of the floor concrete and the spacing of the secondary beams. The calculation method is very technical. It is calculated based on the relevant data such as the section modulus and section moment of inertia of the floor slab.
2. The profile is made of cold-rolled steel plate (coil). The common specifications of the thickness of the steel plate are 0.75mm, 1.0mm and 1.2mm. When the thickness of the steel plate is greater than 1.2mm, the forming is difficult. The main problem is that the stud cannot be penetrated. The profiled steel plate and the steel beam are firmly connected, so it is recommended that the floor support plate thickness should not be greater than 1.5mm.