Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
More information facilitates better communication.
Submitted successfully!
We will call you back soon!
Leave a Message
We will call you back soon!
Your message must be between 20-3,000 characters!
Please check your E-mail!
—— Moyo
—— Octavio
—— Cristian
—— Spence
—— Samuel
—— Ali
1.First turn on the power, turn on the key switch on the control panel, and then press the oil pump to start, so you can hear the sound of the oil pump rotating. (The machine does not move at this time)
2. Followed by stroke adjustment, the use of bending machine must pay attention to adjust the stroke, must be tested before bending. When the upper die of the bending machine descends to the bottom, there must be a gap of plate thickness. Otherwise it will cause damage to the mold and machine. The adjustment of the stroke is also electric fast adjustment and manual stomach adjustment.
3. The next step is the selection of bending notch. Generally, the notch with a width of 8 times the thickness of the plate should be selected. For bending a 4mm sheet, a notch of around 32 is required.